Quick Questions

[Sammm]

^Pretty sure it depends on the lever. Some levers the cable will come out along the underside of the bar and goes under the tape, some (I guess higher end levers) will run the cable through the bars. If yours goes through the bars, you will of course need a hole for the cable to exit.

[Kinchy]

Almost definitely no. If you need a hole, it will alread have a hole.

[Admiral Ackbar]

phil wood definitely makes flip/flop fixed/free hubs. and fyi you can thre

Do Phil Wood make a track rear hub with a fixed cog on one side and a freewheel on the other? I can't see anything on their site.

When putting barend brakelevers on bullhorn bars does the cable go inside the bar and would I need to drill a hole for it to go to the callipers?

PW fixed/free hub 120 spaced : http://www.bikeman.com/BTI-PW81236.html?
utm_source=GoogleBase&utm_medium=GoogleBase&utm_campaign=GoogleBase&gclid=CIyWnfT5wbcCFQbNOgoda0cAFg

cable routing is all down to the bars, if theres two holes near the stem, run it internally, if not go under the tape

[hugh.]

Perfect. thanks guys.

[Narcoleptic Insomniac]

Will my Odyssey Classic Race fork take a 2.35" Fly Ruben or should I just go with the 20.15"? The rim is a Hazard Lite.

[mrjimyjohn]

I really doubt it would fit, those fuckers inflate pretty wide.

[Prodigal Son]

My 2.15 Ruben is roughly the same width as a 2.35 aaron ross.

[Narcoleptic Insomniac]

2.15" Ruben it is then. Thanks dudes.

[Zoidberg]

can you convert a federal v2 (i think) freecoaster to female?

[tim_sch]

There are no V3 or Greyhound replacement axles available, so I'd guess no.

[Spev]

can you convert a federal v2 (i think) freecoaster to female?

Sure you can. You can either cut, drill and tap it out yourself, Have some one else do it for you, or buy one of the aftermarket axles from companies using KHE style internals.

[smalley]

What will stop my eclat tibia cranks wobbling?

[mrjimyjohn]

What will stop my eclat tibia cranks wobbling?

T/Wom/thunderbolts.























Sorry, I had to. Locktite or plumbers tape often work as a band aid fix, but if it's actually worn splines causing the problem there isn't a whole lot you can do about it. Is it the drive or non drive side? Edit: nevermind, tibias are actually welded 2 piece aren't they?

[NewYorkRider]

Is there a hubguard for a v2 hazard hub that wont spread frame kinda like the knight guard for the primo.

[Brooklynrider]

BSD for the odyssey