FBM Re-Releasing the Angel of Death?

[RighteousBMX]

FBM destroying without mercy to benefit the Aryan race or something?!???!?

[BKFBM]

75deg HT
71 ST
11.75" BB
9" S/0
13.5" slammed


there ya go

[GUMP_]

75deg HT
70 ST (i think)
9" standover
11.6" bb
13.5" rear slammed

subject to change.

75
71
9"
13
Come at me
Plus welded mounts

[BKFBM]

welded mounts might be an option, that's too short of a rear end. get a hardway if that's what you're looking for

[skateparkrider]

Sounds like you get your "hard on" from barking out commands....   

Pretty stoked on this happening.  That isn't my cup of tea on geometry.  But I am stoked it is still getting made. 

[dude...]

i just found out ive got some more work coming up real soon so pulled the trigger on one of these. been wanting to try a slightly longer back end again for a bit, so should be sweet.

[streetStreet]

Will of soon hand.

[chubbs]

for some reason my internet wont load the link
I like fbm shit.

I have nothing important to add to the thread

[Prodigal Son]

Putting plants up on eBay to raise some dollars for a frame fork.

[mattywatty]

I'm pretty sure I'm going to be ordering one of these. I had the original AOD 10 years ago when I first started riding. It was my first "real" aftermarket frame. Stoked as hell they're re-releasing it and the geometry is pretty much fine with me. I'm not super picky about geometry, as long as it's not anything extreme like a super short or super long backend or some super steep or super mellow head tube angle. I'm actually going to call FBM to see if they'll make one with welded CS guards (like the old T-1 Byrnes Barcodes and 1st gen SFA). If they could that would pretty much seal the deal for me.

[Sasha]

I'm gonna get one of these to put next to my Barcode and not ride. Can't wait.

[ss1980]

stoked fbm is doing this one again.  hell of a revival! 

i'm not really digging the looks of the ass end of it though.  the diameter of the stays look too small for the toptube junction.  wish they would of used a bit bigger tubing... would look more proportionate.

even so, iconic frame and re-release.

[meathead]

FBM destroying without mercy to benefit the Aryan race or something?!???!?

pretty sure no one else got that 


anyone heard when these will be sent out? meant to have been november , then december and ive still not heard anything?

[Mychaylo]

Some guys on bmxmuseum have theirs already so im not sure, they were pre-order though if i remember.

[meathead]

mother fuckers , im hoping they aren't from England  if so that's just a complete pisstake