Here's some pictures from Kurts coverage of Interbike this year.
Looks like the set screws on the pawl ramp piece tighten down on the bushing giving it some friction on the axle. The pawls look like they get restricted down into the hub with a traditional pawl clip.
As long as there's more friction there at the "ramps" than the clip puts on the pawls, then everything will function fine.
The pawl ramps look like they function identical to the way the Eastern/Ezra hub works, in that as the pawls move forward they slide up on ramps on a washer next to them pushing them up to engage the ratchet ring.
The big difference between this and the Eastern, though is that the Blind has a totally different ratchet ring that has it's teeth spaced out a lot more to allow more slack at times. Makes me wonder though, if the slack stays consistent all the time?
Allllriiiiight.
I am going to have to look it up but it looks like a couple concepts that Sturmey Archer incorporated in their internal gear hubs- but then german-ed up a bit. I have exploded view sheets, problem is; it's going to be one of the dozens of different designs of the last 20/30 years.
Give me a day, i'll get back on this.
Mainwhile i have to agree that the high speed engaging might result in stressed parts but the lesser engagement points should help the case. Nobody really goes backwards upwards of what? 20mph? tops
If the engagement is click-on and click-off, i think the high speed engagement issue might not pose a problem at all.
With KHE i think the problem was moving your cranks while fakieing, and then suddenly engaging.
If the Blind works the way i think it does, the above might be a bit less/eliminated.
I'm stupid though.
Topic: I'm so bliiiiiiiind (Read 30169 times)
