Ratchet collars

[streetStreet]

Is empire the only place to get them? I have a bluesix in the drive side but it needs teackng and can't find my original.

Halp

[blueee]

Teaking?

[streetStreet]

Replacing whoops sorry iOS and me are terrible.

[blueee]

What did you do to it? I may have extra set on standby

[streetStreet]

What did you do to it? I may have extra set on standby

Hey Carlos,

I out replaced mine with the blue six ones but they're wearing out, the collar looks a bit ground into. I can't find my
Old collars and I'm in Canada.

[couch]

I have a few 6/4 titanium ones. Have nondrive side for sure. I'll check for drive sides. Shoot me an email if you're interested. info@zodiaceng.com

[streetStreet]

I have a few 6/4 titanium ones. Have nondrive side for sure. I'll check for drive sides. Shoot me an email if you're interested. info@zodiaceng.com

The OG collar is actually on the hub. I'm using a B6 ti axle but will switch it out for the chormoly one to see if that changes anything.

What could cause this hub to wobble?

[blueee]

Your circlip isn't holding in place. You pop it back in everytime you reassembled you driver but it pops right back out, pull it out and open it up a bit so the diameter increases by a tiny bit. You'll notice it is now a little harder to pop back into the groove it fits in. But it will also be a lot harder for it to pop out on its own. One of the old 9t drivers?

[streetStreet]

Your circlip isn't holding in place. You pop it back in everytime you reassembled you driver but it pops right back out, pull it out and open it up a bit so the diameter increases by a tiny bit. You'll notice it is now a little harder to pop back into the groove it fits in. But it will also be a lot harder for it to pop out on its own. One of the old 9t drivers?

Brand new 9 tooth from empire. Hadn't had time to work in my bike right yet though.

[G]

I have a few 6/4 titanium ones. Have nondrive side for sure. I'll check for drive sides. Shoot me an email if you're interested. info@zodiaceng.com

The OG collar is actually on the hub. I'm using a B6 ti axle but will switch it out for the chormoly one to see if that changes anything.

What could cause this hub to wobble?

Problems with the driver shouldn't cause the hub itself to wobble. If the hub can wobble either something is missing or wrongly assembled, or the bearings are toast, or the bearings are loose in the hub-shell (super rare with our hubs though).

Double check everything, and try to feel where the wobble is.


G.

[pegs]

sounds like the collar has been squashed a touch, if you filed/sanded the end of the axle down slightly it should stop the wobble, at worst a bearing might've got fucked

[streetStreet]

Thanks for the comments and yes the washer on the outside of the driver was indeed missing. Not the long washer, but the short one.