always curious how a brazed frame would hold up?
Don't think it should be a problem. Curtis Bikes in the UK makes brazed BMX frames (racing) and I've heard nothing bad about them. There are many custom MTB makers who braze as well (including bikes intended for enduro and DH).
Brazed joints are very strong, generally the tube will fail before a brazed joint. Whether this applies to thicker BMX tubing I'm not too sure but I'm sure if done well it will be just as good as a TIG weld.
That's what my research has shown as well. Main difference is just time. Brazing takes longer and requires more finishing work - at least if you want to go for the smooth fillet look.
Pretty sure I recall you always having sick bikes. This is no exception. Would love to see how everything holds up. Have you ridden a brazed frame before?
Cheers. Quite happy with this one.
I don't ride as hard anymore, so I'm probably not the one who'd break this frame even if it was made from styrofoam. Haha!
Either way I did a bunch of testing of my brazed joins before actually making a frame and a 90 single degree T-join made from top tube sized tubing supported my entire body weight.
Also tried to pull apart/twist/break joins made from smaller diameter tubing by clamping it in a vice and attaching an extension bar. As the doctor said above, the steel tube failed before I could even see the join being affected. Good sign.
Topic: Handbuilt (Read 20514 times)
