The Street > Common Questions and former stickies.
common bearing and bolt/nut sizes
brian itzaina:
any one know the size and tpi for drilling and tapping a frame for removable gyro mounts?
Tubes6al4v:
M3 x 0.5
http://www.bmx-u.com/index.php?title=Adding_Gyro_Tabs
brian itzaina:
Thanks^
Alice Glass:
I'm not sure this belongs on here, but I would like to know if a 16t Shimano freewheel will fit a rear Homer. Thanks
Tubes6al4v:
Homers used to be available in both small (metric, for going down to 13t) and large (SAE? for 16+ freewheels) threads. If yours is one of the newer (Taiwan) hubs, then no, it won't work.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version