1
Bike Gallery / Bikes you miss
« on: March 06, 2013, 08:59:07 AM »
Proper TTL bikesmile2
Multimedia |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Barrel adjuster. Odyssey monolever barrel adjuster to be precise
If the part is anoed then there is a few ways you can strip it, The best way I have found is dollar store oven cleaner. spray the part let it sit for no more than 15 min and scrub the hell out of the part with fine steel wool and then rinse the part and repeat until the part is a dull raw color similar to this.
You really shouldn't let oven cleaner get onto the bearing seats. It works by eating away the aluminium so you will be fucking up the bearing seat tolerances very quick. Decorative anodising (like hubs use) should buff off pretty fast with a polishing wheel and you are not going to fuck the bearing seats.
G.
Tell them " Sheepdog sent you", for a little something special |
Click this image for a little something special |